Precision suppressors

A precision suppressor does two things: it keeps your point of impact where it was, and it holds up to real use. We build ours to do both. Every Unorthodox suppressor is 3D-printed in Grade 23 titanium, heat treated, and machined to a tolerance that keeps the bore lined up with your barrel, by an ISO 9001 and AS9100 certified manufacturer in the USA.

What makes a suppressor precise

On a suppressor, precision comes down to alignment. If the mounting threads and the bore aren't perfectly concentric, the bullet can clip a baffle, and your point of impact shifts. Here is how we get it right.

1. Laser powder bed fusion (LPBF) titanium

Each can is printed with LPBF in Grade 23 titanium, the same alloy used in aerospace parts. Printing builds the baffle geometry as one solid piece, with no stack of separately machined parts to misalign.

2. Specialized heat treatment

After printing, every can goes through a specialized heat-treating process that relieves stress and gives the titanium its strength, so it holds its shape under repeated fire.

3. Mounting threads cut in a single setup

The ends are precision machined with all mounting threads cut at the same time. One setup means the threads share a single reference, which is what gives you complete concentricity between the mount and the bore.

4. Gauged at every stage

Each can is tested with custom tool gauges at the manufacturer, then checked again when it arrives after heat treatment and coating. Nothing ships on trust alone.

5. Manufactured under ISO 9001 and AS9100

The parts are made by an ISO 9001 and AS9100 certified manufacturer. These are the quality management standards behind aerospace and defense work.

What the testing showed

We tested the Smokey on an 18-inch Howa 1500 Precision at 100 yards with 62 grain HPBT match ammunition.

  • Point-of-impact shift under 1.5 inches at 100 yards.
  • 0.24 MOA accuracy improvement over the same rifle unsuppressed, measured in third-party testing by Tyler Brewer at Brew Tactical in Tulsa, Oklahoma.

Testing was done with the Smokey. The Spooky shares its body, low back-pressure design and mounts.

Pick your precision suppressor

  • Smokey: AR-15s and rifles up to .26 / 6.5mm. 6 in, 10 oz, 1/2x28 and 5/8x24 mounts included.
  • Spooky: magnum-rated centerfire up to .36. 6 in, 10 oz, 1/2x28 and 5/8x24 mounts included.
  • Short Stack: 9mm pistols, 3.75 in, 2.5 oz, no booster needed.
  • Split: .22 rimfire, 4 in, 3.5 oz, opens to clean.

See the full lineup and comparison on the suppressors page.

Frequently asked questions

What is a precision suppressor?

A suppressor built to tight tolerances so the bore stays concentric with your barrel. That keeps baffle strikes out of the picture and keeps your point of impact consistent.

Will a suppressor change my point of impact?

Any suppressor can shift it a little. With the Smokey on an 18-inch Howa 1500 Precision shooting 62 grain HPBT match at 100 yards, the shift measured under 1.5 inches.

Is a 3D-printed titanium suppressor strong enough?

Yes. LPBF Grade 23 titanium followed by heat treatment gives high strength at low weight. The Spooky is rated for magnum centerfire calibers.

How do you check each suppressor?

With custom tool gauges at the manufacturer, and again after heat treatment and coating.

How do I buy one?

Order here, and we ship to your local FFL/SOT dealer. Plan on about 35 to 45 days. Contact us if you need help finding a dealer.